Hydro-Smart 115 - Initial Operation Checklist

InitialOperation
25│Page



 ChecktheGASandWATERCONNECTIONSforleaksbeforefiringunitforthefirsttime.
 Openthemaingassupplyvalvetotheunitusingonlyyourhandtoavoidanyspark.Neveruse
tools.Iftheknobwillnotturnbyhand,donottrytoforceit;
callaqualifiedservicetechnician.
Forcedrepairmayresultinafireorexplosionduetogasleaks.
 Besuretocheckforthepresenceofleakinggastowardthebottomoftheunitbecausesome
gasesareheavierthanairandmaysettletowardsthefloor.
 Check
theGASPRESSURE.Refertop.19.
 Donottrytolighttheburnermanually.Itisequippedwithanelectronicignitiondevicewhich
automaticallylightstheburner.
 CheckforPROPERVEN TINGandCOMBUSTIBLEAIRtothewaterheater.
 PurgetheGASandWATERLINEStoremoveany
airpockets.
 Donotusethiswaterheaterifanyparthasbeensubmersedunderwater.Immediatelycalla
qualifiedservicetechniciantoinspectthewaterheaterandtoreplaceanydamagedparts.

INITIALOPERATION
1. Refer to p. 31 for
instructions.
2. Fully open the manual
water control valve on the
watersupplyline.
3. Open a hot water tap to
verify that water is
flowingtothattap.





Thenclosethehotwatertap.
4. Fullyopenthemanualgas
controlvalveinstalled. 






5. Turn on the 120 volt 60 Hz
power supply to the water
heater.
6. Now you are ready to
enjoy hours of endless
hotwater.
FORYOURSAFETY,READBEFOREOPERATING
IFYOUSMELLGAS:
 Donottrytostartthewaterheater.
 Donottouchanyelectricswitches;donotuseanyphoneinyourbuilding.
 Immediatelycallyourgassupplierfromaneighbor’sphone.Followthegas
supplier’sinstructions.
 Ifyoucannotreachyourgassupp lier,callthefiredepartment.

WARNING