Hydro-Smart 115 - Error Code Diagnostics; Error Code Display and Interpretation

Troubleshooting
34│Page
ERRORCODES

Theunitsareselfdiagnosticforsafetyandconveniencewhentroubleshooting.
 If there is a problem with the installation or the unit, depending on the model or if there is a
remotecontrollerinstalled,itwilleitherdisplayablinkingredLED,ortheerrorcodewilldisplayon
theremotecontrollerifitisinstalled.
 Consultwiththetableonthefollowingpageforthecauseofeacherrorcode.



‐Singleunitinstallations‐

Example:Ifyourunitdisplaysthe“321”errorcode(whichsignifiesaninletthermistorfailure)
 Hydro‐Smart115:TheredLEDonthecomputerboardwillbeblinkingtwotimes. 
 Iftheremotecontroller9007666005(TK‐RE02)isinstalled:“32”willdisp layonthescreeninits
entirety.
Errorcodeonthe remote
controller9007666005(TK‐RE02)
Errorcodeonthecomputerboard
RedLED