Hydro-Smart 115 - Troubleshooting: Unit and Remote Controller; Water Heater Operational Issues

Troubleshooting
33│Page
‐WATERHEATER‐
PROBLEM SOLUTIONS
Unitdoesnotignitewhen
watergoesthroughtheunit.

 Istheflowrateover0.5GPM?(p.28)
 Checkforreverseconnectionandcros sconnection.
 Ifyouusetheremotecontroller,isthepowerbutton
turnedon?
 Checkiftheinlettemperatureistoohigh.
Thefanmotorisstill
spinningafteroperationhas
stopped.


 Thisisnormal.Afteroperationhasstopped,thefanmotor
keepsrunningfrom15to70secondsinordertore‐ignite
quickly,aswellaspurgeallthe exhaustgasoutoftheflue.
Unitsoundsabnormalwhile
inoperation

 ContactHydro‐Smart.
‐Remotecontroller‐
(OPTIONAL)‐
Remotecontrollerdoesnot
displayanythingwhenthe
powerbuttonisturnedon.
 Makesuretheunitissuppliedwithpower.
 Makesure theconnectiontotheunitiscorrect.(p.22) 

AnERRORcodeisdisplayed.
 Pleaseseep.34‐36.