Hypertherm powermax65 User Manual

Maintenance and RepaiR
powermax 65/85 Operator Manual 5-7
Fault
code
Description Power
LED
Fault
LED
Fault
icon
Solutions
0-21 Gas flow lost while
cutting
On On • Restore the gas inlet pressure and restart the power
supply.
• Check the torch lead for leaks or kinking.
0-22 No gas input On On • Connect the gas source and restart the power
supply.
0-30 Torch consumables stuck
This indicates either a
“torch stuck open” or
a “torch stuck closed”
situation.
On On
• If the consumables became loose or were removed
while the power supply is ON, turn OFF the power
supply, correct the problem and then turn ON the
power supply to clear this fault.
• If the consumables appear to be installed
correctly, the torch may be damaged. Contact your
Hypertherm distributor or authorized repair facility.
0-40 Over/under temperature On On • Leave the power supply on to allow the fan to cool
the power supply.
• If the internal temperature of the power supply
approaches -22°F (-30°C), movethe power supply
to a warmer location.

Hypertherm powermax65 Specifications

General

Brand	Hypertherm
Model	powermax65
Category	Welding System
Language	English