Hypertherm powermax65 - Single-Phase Power Cord (Not for CE Model)

Power SuPPly SetuP
powermax 65/85 Operator Manual 2-9
Single-phase power cord (not for CE model)
To operate your Powermax85 on 1-phase power, you will need to install an appropriate power cord. Refer to 2-10
Single‑phase power cord installation for instructions.
Caution: When using the Powermax85 CSA model power supply (CE model is 3-phase
only) with a 1-phase power source, replace the supplied power cord with a
6AWG (16 mm
2
) 3-wire power cord. The power cord must be connected by a
licensed electrician.