Hytera DS-9300 - Page 56

Appendix: Parameters User Manual
50
Inspection Report
 1: Report
 0: Do not report
/
Troubleshooting Report
 1: Report
 0: Do not report
/
Configuration Change
Report
 1: Report
 0: Do not report
/
Downlink PA Over-current
threshold
The range is 0 to 65535.
/
Uplink/Downlink Squelch
Threshold (dBm)
The range is –110 to 50. /
Uplink/Downlink Squelch
Switch
 0: Enable
 1: Disable
/
Remote Unit Delay
Auto-compensation Switch
 0: Enable
 1: Disable
/
Uplink Digital Attenuation
(dB)
The range is 0 to 20. /
Downlink Digital
Attenuation (dB)
The range is 0 to 20. /
Monitor Board Software
Version Switch
 0: Do not switch
 1: Switch
/
Digital Board Software
Version Switch
 0: Do not switch
 1: Switch
/
FPGA Software Version
Switch
 0: Do not switch
 1: Switch
/
Uplink Operating Channel
(MHz)
This parameter is subject to actual
requirements.
/
Downlink Operating
Channel (MHz)
This parameter is subject to actual
requirements.
/