Hytera HR106X - Installation; Installation Requirements; Pre-installation Tasks; Installation Procedure

7
3. Installation
To ensure optimum performance and reliability of the repeater, read the following instructions carefully.
3.1 Installation Requirements
3.1.1 Environmental Conditions
The repeater must be installed in a dry and well-ventilated place. The operating temperature ranges from –30°C to
+60°C, and the relative humidity is 95%.
3.1.2 Installation Site
The repeater can be installed in a rack, bracket, and cabinet, or on a desk.
For more information, refer to the Safety Information Booklet.
3.2 Pre-installation Tasks
3.2.1 Preparing the Tools

Phillips screwdriver

T-10 torx screwdriver

Spanner

Anti-static gloves

Multimeter
3.2.2 Checking the Power Supply
Before you install the repeater, make sure that the power supply meets the following requirements:

DC power voltage: 13.6±15% V

AC power voltage: 100–240 V
3.3 Installation Procedure
To install the repeater, do as follows:
1. Wear the anti-static gloves.
2. Place the repeater to a proper location.