Hytera HR65X - Installation; Tools; Procedure

User Guide
Installation
7
4. Installation
You can place the repeater on the desk, or install the repeater on the wall.
4.1 Tools

Electric drill

Screwdriver

Wrench

Anti-static gloves
4.2 Procedure
Install the three pegs onto the fixing plate with three M3 screws at holes marked with "B".
Fix the fixing plate to the back of the repeater with four M4 screws.
Install the repeater on the wall.
Before installation, make sure the weight of the repeater is within the load bearing capacity of the wall.
a.
Hold the bracket horizontally to a proper position on the wall, and then mark the locations of the three holes
(
Φ
= 8 mm, h = 60 mm) as anchor points.