Hytera HR65X - Troubleshooting

Troubleshooting
User Guide
18
8. Troubleshooting
Phenomena
Analysis
Solution
The repeater
cannot be turned
on.
The power cord may be disconnected or get
loose.
Re-connect the power cord.
The fuse in the DC power cord may be damaged.
Replace the fuse.
The repeater
cannot
communicate
with a radio.
The TX/RX frequencies or the color code of the
repeater may be inconsistent with that of the
radio.
Reset the frequencies or color code.
The continuous tone controlled squelch system
(CTCSS)/continuous digital controlled squelch
system (CDCSS) of the repeater may be
inconsistent with that of the radio.
Reset the CTCSS or CDCSS.
The repeater may suffer severe interference.
Keep the repeater away from the
interference source, or change the
frequencies.
The radio may be out of the communication
coverage of the repeater.
Move the radio towards the communication
coverage of the repeater.
The antenna is disconnected.
Reconnect the antenna.
Within the
communication
coverage of the
repeater, the
radio suffers
short
communication
distance and poor
audio quality.
The cable may be damaged.
Repair the cable, or replace the cable if
necessary.
The antenna may get loose or be disconnected.
Re-connect the antenna properly, or replace
the antenna if necessary.
If the above solutions cannot fix your problems, or you may have some other queries, contact the Company or your
dealer for more technical support.