Hytera HR65X - Alarm Information

Alarm Information
User Guide
12
7. Alarm Information
With the Alarm feature enabled by your dealer, the repeater automatically triggers an alarm if any exception occurs.
When the alarm is active, the LED displays the corresponding alarm code and the alarm indicator glows red.
The following table describes alarms in detail.
Alarm
Code
Alarm Name
Description
E3
External power
under-voltage alarm
The repeater fails to work. In this case, if the Repeater Backup feature is
enabled on the CPS, the repeater starts a backup.
E4
TX unlocked alarm
The repeater fails to work. In this case, if the Repeater Backup feature is
enabled on the CPS, the repeater starts a backup.
E5
RX unlocked alarm
The repeater fails to work. In this case, if the Repeater Backup feature is
enabled on the CPS, the repeater starts a backup.
E6
PA over-
temperature alarm
The repeater fails to work. In this case, if the Repeater Backup feature is
enabled on the CPS, the repeater starts a backup.
E7
Voltage standing
wave ratio (VSWR)
alarm
The repeater automatically works at lower TX power.
E8
Off-lease alarm
The repeater fails to work.
E9
Slave unregistered
alarm
The repeater cannot repeat the signal or data in the IP multisite connect
network.
EE
Repeater disabled
alarm
The repeater fails to work.
Eb
Low forward power
alarm
The repeater stops transmission when the TX power is 0 W.
EH
External power
over-voltage alarm
The repeater fails to work. In this case, if the Repeater Backup feature is
enabled on the CPS, the repeater starts a backup.
H3
Network IP conflict
alarm
Network services of the repeater are unavailable.
H5
Invalid network IP
alarm
Network services of the repeater are unavailable.