Hytera HR65X - Solution; Off-Lease Alarm; Description; Slave Unregistered Alarm

User Guide
Alarm Information
15
In this case, the repeater automatically works at lower TX power.
7.4.2 Solution
Check whether the TX frequency is within the frequency range of the antenna.
 If yes, go to step 2.
 If no, contact your dealer to replace the antenna.
Check whether the RF adapter cable, antenna, or feed line is properly connected.
 If yes, contact your dealer for technical help.
 If no, re-connect or replace the cable, antenna, or feed line.
7.5 Off-lease Alarm
7.5.1 Description
When the rental time of the repeater expires, the alarm indicator glows red and the LED displays "E8".
In this case, the repeater fails to work.
7.5.2 Solution
Contact your dealer to extend the rental lease.
7.6 Slave Unregistered Alarm
7.6.1 Description
In the IP multi-site connect network, if the repeater works as a slave one and fails to send a registration request to the
master repeater, the alarm indicator glows red and the LED displays "E9".
In this case, the repeater cannot repeat the signal or data in the IP multi-site connect network.
7.6.2 Solution
Check and modify the network configuration.
7.7 Repeater Disabled Alarm
7.7.1 Description
With the Repeater Disable feature enabled by your dealer, when the repeater detects the active level, the alarm indicator
glows red and the LED displays "EE".