18
9. Troubleshooting
Phenomena Analysis Solution
The radio fails to
power on.
The power cord may be
disconnected.
Connect the power cord properly.
During receiving,
the voice is weak,
discontinuous or
totally inactive.
The volume level may be low.
Increase the volume by rotating the Volume
Control Knob.
The antenna may be loosened
or improperly installed.
Power off the radio and reattach the antenna.
The speaker may be blocked
or damaged.
Clean the surface of the speaker. If the
problem cannot be solved, contact your dealer
or our authorized service center for inspection
and repair.
You cannot
communicate with
other members in
analog mode.
The frequency or signaling may
not match that of other
members.
Set your TX/RX frequency and signaling to the
same as that of other members.
You may be too far away from
the group members.
Move towards other members.
In digital mode,
there’s RX
indication on the
radio, you cannot
communicate with
other members.
The digital carrier may be
received but may not be
demodulated due to
inconsistent ID with that of
other members.
Sets the same ID of other members.
Irrelevant
communication or
noise is heard on
the channel.
You may be interrupted by
radios using the same
frequency.
Adjust the squelch level.
The radio may be set with no
signaling.
Set your radio with signaling to avoid
interference at the same frequency, and make
sure that all members share the same
signaling.
To Next Page
Loading...
Need help?
General
