Phenomena Analysis Solution
The channel type (digital or analog) may be set incorrectly. Verify that you are on the correct digital or analog channel.
You may be too far away from other members. Move towards other members.
The signal is poor. Make sure call participants are within the communication range.
You hear unknown voice or noise.
You may be interrupted by radios using the same frequency. Change the frequency, or adjust the squelch level.
The radio may be set with no signaling.
Request your dealer to set signaling for all member radios to
avoid interference at the same frequency, and make sure that all
group members share the same signaling.
During receiving, you hear too much noise
and hiss.
The signal is poor. Make sure call participants are within the communication range.
You may be in a position with poor signals, such as near a high building or
in an underground area.
Move to an open and flat area, restart the radio, and try again.
It may be the result of external disturbance (such as electromagnetic
interference).
Stay away from equipment that may cause interference.
If the above solutions cannot fix your problems, or you may have some other queries, contact your dealer or the Company for more technical support.
32
To Next Page
Loading...
Need help?
General
