Hytera DMR System Planner
114
Digital channel setting:
Color Code
Configure the channel color code (range: 1-15).
IP Multi-site Connect
Configure whether to retransmit the signal via IP network and specify a time slot.
RX Frequency
Configure the RX frequency.
TX Frequency
Configure the TX frequency.
Analog channel setting:
Channel Spacing
Configure the bandwidth of the TX frequency and RX frequency.
Carrier Squelch Level
For better communications, you can set the squelch level of the repeater.
Multi CTC/CDC codec
Set whether the Multi CTC/CD table is applied during decoding.
Pre-emphasis
Set whether the audio would be pre-emphasized.
Scrambler
Set whether the signal will be encrypted.
Flat Audio
Set the way of the output of the audio signal from the accessory pin.
Receiving
Set RX frequency
Set CTCSS/CDCSS type.
Set CTCSS.
Set CDCSS
To Next Page
Loading...
Need help?
General
