Hytera DMR System Planner
115
Transmitting
Set the TX frequency.
Set TX CTCSS/CDCSS type.
Set CTCSS.
Set CDCSS code
Mixed channel setting:
Channel Spacing
Configure the bandwidth of the TX frequency and RX frequency.
Carrier Squelch Level
For better communications, you can set the squelch level of the repeater.
Color Code
Set whether the CTCSS/CDCSS table is applied during decoding.
Type of PTT TX Channel
Set the channel for transmitting audio.
Pre-emphasis
Set whether the audio would be pre-emphasized.
Scrambler
Set whether the signal will be encrypted.
Flat Audio
Set the way of the output of the audio signal from the accessory pin.
Receiving
Set RX frequency
Set CTCSS/CDCSS type.
Set CTCSS.
Set CDCSS code
Transmitting
Set the TX frequency.
Set TX CTCSS/CDCSS type.
Set CTCSS.
To Next Page
Loading...
Need help?
General
