Hytera PNC360S - Settings; Wireless and Network; Cellular Network; WLAN Network

13
4. Settings
In the
Settings
menu, you can configure the network, radio, and system.
4.1 Wireless and Network
4.1.1 Cellular Network
Before connecting to the cellular network, make sure that the Nano SIM card is installed and the cellular data
service is activated.
Press the
Navigation
key to select
Data usage
, and then press the
OK/Menu
key. You can perform the following
operations.
Enabling the Cellular Data
Press the
Navigation
key to select
Cellular data
, and then press the
OK/Menu
key.
Checking the Data Usage
Press the
Navigation
key to select
Cellular data usage
, and then press the
OK/Menu
key.
You can view the amount of data usage to avoid exceeding the data usage limit.
Enabling the Data Roaming
1. Press the Navigation key to select Mobile network settings, and then press the OK/Menu key.
2. Press the OK/Menu key to enable Data roaming.
You can access data services when you are outside the service area of your network provider.
Selecting the Network Type
1. Press the Navigation key to select Mobile network settings, and then press the OK/Menu key.
2. Press the Navigation key to select Preferred network type, and then select the network.
4.1.2 WLAN Network
After successful WLAN connection, you can visit the Internet or shared media from other devices in the network.
To connect the radio to the WLAN network, do as follows:
1. Press the OK/Menu key to enter the WLAN interface.
2. Press the OK/Menu key to enable WLAN.