Hytera PNC360S - Upgrade

19
Press the
Navigation
key to select
Factory data reset
, and then press the
OK/Menu
key three times.
4.3.3 Date and Time
The radio can automatically synchronize with the local date, time, and time zone over a cellular network or allows
you to manually set them.
Setting the Date, Time, and Time Zone
1. Press the Navigation key to select Date & time, and then press the OK/Menu key.
2. Press the Navigation key to select Automatic date & time or Automatic time zone, and then do one of the
following:
If you want to … You can …
Enable the radio to update the date, time,
and time zone automatically
Press the
OK/Menu
key to enable the option.
Set
the date, time, and time zone
manually
3. Press the OK/Menu key to disable the option.
4. Press the Navigation key to select Set date, Set time
, or
Select time zone, and then press the OK/Menu key.
5. Specify the date, time, or time zone.
4.3.4 Upgrade

Do not upgrade the radio system with unauthorized software to avoid radio failure, data loss, or potential
security problems.

Be sure to back up your data before upgrade.

Ensure that the battery power is above 50% before upgrade.

During the upgrade, do not remove the battery.
When an update is available, you can upgrade the system in one of the following ways :

In Auto-Upgrade mode, you can download the firmware package from the MDM server through the
WLAN network.
a.
Press the
Navigation
key to select
System upgrade
, and then press the
OK/Menu
key.
b.
Follow the on-screen instructions to download and install the upgrade package.