10
Assembly and Disassembly
Removing the Battery
1. Turn off the radio, if it is turned on. Then follow step 1 in the section
“
Attaching the Battery
”
to remove the rear cover.
2. Hold the top part of the radio's body, and lift the battery in the direction of
arrow
①
by the notch at its bottom, and then remove the battery from the
radio's body in the direction of arrow
②
, as shown in Figure 4.
Attaching/Removing the Belt Clip
Attaching the Belt Clip
Align the two screw holes on the metal bracket of the belt clip with holes on
the elliptical protrusion on the back side of the radio. Then secure the belt clip
on the
Fig.3
Fig.4
Note: If the rear cover is not well locked, please remove the rear cover and
attach it again.
To Next Page
Loading...
