22
(3) Specification of input and output signal and wiring material
Connecting plug is
standard attachment.
MC1.5/6-ST3･81
(PHOENIX CONTACT)
Connecting plug is
standard attachment.
MC1.5/4-ST3･5
(PHOENIX CONTACT)
The gateway unit
incorporates a terminal
resistor, therefore,
connect the terminal
resistor to the end of the
SIO communication.
Connecting plug is
standard attachment.
It is necessary to connect
a terminal resistor to both
ends of the CC-Link
system (between DA and
DB), therefore, check the
Operation Manual for the
master side (PLC).
Connector and applicable electric wire
0.8 – 1.3mm
2
AWG 18 – 16
0.08 – 1.5mm
2
AWG 28 - 16
0.08 – 1.5mm
2
AWG 28 - 16
Two-paired twist
shielded cable
(AWG22)
Recommended
brand: Taiyo Electric
Wire & Cable
HK-SB/20276 XL
2P × AWG22
CC-Link Ver. 1.10
supporting
dedicated cable
(Such as
FANC-SBH,
FANC-SB)
Specification
24V DC ±10%
Consuming current 300mA
max.
Allowable load voltage: 30V
DC
Allowable load current: 1A
No voltage (dry) contact input
load: 24V DC 7mA
Set GND (ground) level to that
of controller or ERC actuator
to be connected.
Internally connected to frame.
Internally connected.
Contents
Gateway power supply Positive
side of 24V DC
Gateway power supply Negative
side of 24V DC
Teaching box emergency stop
signal output
External port switching input
SIO communication line A
SIO communication line B
Ground
Frame ground
CC-Link communication line A
CC-Link communication line B
CC-Link communication ground line
Shield
Frame ground
* The gateway unit is provided with the following one terminal resistor respectively. Since the terminal resistor depends on the
CC-Link cable to be used, use a resistor suitable for the cable.
Cable FANC-SBH
(CC-Link dedicated high-performance cable) 130Ω, 1/2W
Cable FANC-SB
(CC-Link dedicated cable) 110Ω, 1/2W
Symbol
24V
N
S1
S2
PORT
IN
PORT
N
SDA
SDB
GND
FG
DA
DB
DG
SLD
FG
Power supply
input connector
SIO
communication
connector
CC-Link
communication
connector
To Next Page
Loading...
Need help?
General
