12
Tech Support: (877) 591-2491
The attachment here is via a common “V” spring. To
remove simply pinch the two sides of the spring together
and slip out of the “C” shaped brackets on the inside walls
of the lighting fixture.
The trim ring and reflector may also be attached to the
inside of the recessed lighting fixture with small springs.
Reach inside the lighting fixture, grasp the spring at the
top hook, and lift it off of its point of attachment. There
are usually two springs one on either side of the fixture.
For more information on removing this type of trim ring
see the section titled “More on Removing Trim Rings and
Reflector” on page 28 in this manual.
The Edison Socket may also be attached to a socket arm
(L-shaped bracket) or to a socket plate (flat circular piece
of metal). Many times this “arm” or “plate” can be adjusted
via a wing nut to a depth which is suitable for mounting your
LightSpeaker
®
. In most cases however it is just as easy or
easier to just remove the socket plate all together since it
provides for the quickest and easiest install.
C shaped
bracket
To Next Page
Loading...
Need help?
General