IBC V-10 User Manual

Operational settings in the Advanced Setup Menu
Mode Setting Description
Temp.
Range
Default
Design
Outdoor°
Coldest expected outdoor temperature
typically experienced at the installation
site. Set the Design Outdoor Air
temperature correctly for the geographic
location; consult a local IBC wholesaler or
the heat loss calculation documentation
used in the design of the heating system.
-76 °F-86 °F 14 °F
Design
Indoor°
This setting only becomes available when
the Advanced Reset check box is
checked. The indoor air temperature used
that factors in the heat loss calculations for
the heating space.
41 °F-95 °F 72 °F
Indoor
Setpoint°
This setting only becomes available when
the Advanced Reset check box is
checked.
41 °F-95 °F 75 °F
Summer
Shutdown°
Cut-off level for outdoor temperature that
stops further heating
32 °F-122 °F 65 °F
Maximum
Supply°
Highest supply water temperature 70 °F-147 °F 70 °F
Minimum
Supply°
Lowest supply water temperature 70 °F-147 °F 70 °F
Supply Diff'l Boiler will shut off at half differential setting
when supply water temperature is half the
differential setting below the boiler Current
Target° and fire when the supply water
temperature is half half the differential
setting above the boiler Current Target°
3 °F-62 °F 20 °F
Ramp
Speed
See Ramp Speed on page 91. 1-10 3
Priority See Priority on page 90. Very Low-
Very High
Low
Pump
Purge
See Pump Post Purge (sec) on page 90. 0-900
seconds
0
Indoor
From°
See Indoor ° From on page 89. Indoor / Sec.
Loop
Indoor
Outdoor
From°
See Outdoor ° From on page 90. Outdoor,
Sec. Loop,
DHW
34
Section: Operating concepts

IBC V-10 Specifications

General

Brand	IBC
Model	V-10
Category	Controller
Language	English