6 You will see the
"in
use" light come
on
while the
back-up diskette
is
being written.
Then the message shown in step 4 will appear again.
Hint:
For
this procedure, you can remember which
r"\
diskette
to
insert,
if
you
remember "Original = Source".
Insert
your
original diskette when DISKCOPY asks for
the source diskette.
7 Keep repeating steps 4 and 5 until this message appears:
Copy
complete
Copy
another?
(YIN)
8 Type this:
n
You
don't
have
to
press the
Enter
key.
9 The DOS
prompt,
A>,
is
displayed.
Remove the back-up diskette from the drive. With a
felt-tip pen, mark the label with the contents, the date,
and perhaps the word "Back-up."
Backing
Up
with
Two
Drives
1 Make sure DOS
is
ready and
A>
is
displayed.
2 Insert
your
DOS Diskette
into
drive A:.
3 Type this:
diskcopy
a:
b:
and press the
Enter
key.
DOS
3-62
To Next Page
Loading...
