IBM 5150 - Page 84

Changing the Default Drive
You can change the default drive. To do this, just type
the new drive designator following the
A> prompt, and
press Enter.
For example, to make drive B: the default drive, type:
b:
and press the Enter key. Here's what this looks like on
the screen:
A>b:
The "ci.rsor is here.
Note that now the prompt is B>-just what we wanted.
Now DOS will
look at the diskette in drive B: whenever
you specify a file without the drive specifier.
You can change back
by typing a:. Here's the screen
now.
8>a:
Try this
too.
DOS 3-10