Chapter 8. Additional Service Information 199
Wake on LAN
This setting is used to enable or disable the IBM-developed
Wake on LAN feature. This feature makes it possible for the computer to be turned on
remotely by a network server. Remote network management software must be used
in conjunction with this feature.
To access the Wake on LAN setting, use the following procedure.
1. Start the Configuration/Setup Utility program. See “Setup Utility program” on
page 10.
2. Select Advanced Power Management.
3. Select Automatic Power On from the program menu.
4. Select Wake on LAN from the Automatic Power On menu.
5. To enable Wake on LAN, select Enabled. To disable Wake on LAN, select
Disabled.
6. Press Esc until you return to the Configuration/Setup Utility program menu.
7. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
8. To exit from the Configuration/Setup Utility program, press Esc and follow the
instructions on the screen.
To Next Page
Loading...
