IBM 6400 Programmer's Reference

Graph ics Co mm an d Set
Hex Line Type
03 Right to Left
04 Bottom to Top
Set Character Precision
Description: This order sets the value of the current character precision
attribute. Parameter P1 specifies the type of precision.
39 P1
Table 83. Set Character Precision
Byte Value Description Error Code
0 X'39' Order code
1
X'00'
X'01'
X'02'
X'03'
Precision Type
Drawing default
String Precision
Character Precision
Stroke Precision
X'0300..04'
X'0300..0E'
Set Character Set
Description: This order sets the value of the current character set attribute.
The character set specified by this command must use an NLQ font if printing
high-density graphics or a DP font if printing low-density graphics.
Parameter P1 specifies the local character set identifier. This local ID is mapped
to a global font ID by the Load Font Equivalence command. See “Load Font
Equivalence (LFE)” on page 34.
38 P1
Table 84. Set Character Set
Byte Value Description Error Code
0 X'38' Order code
1
X'00'
X'01'-X'FE'
X'FF'
Local Character Set ID (LCID)
Drawing default
Local ID (LCID) for Character Set
Special Character Set
X'03C3..00'
Set Color
Description: This order sets the value of the current graphics color attribute.
The color for non-graphics (for example, text) does not change with this order.
The color attribute applies to all following graphics drawing orders until another
Set Color order or Set Extended Color order occurs or until a new graphics
segment initializes the graphics attributes. This order does not change any
other graphics drawing attributes.
0A P1
Chapter 3. IPDS Commands Reference 111

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English