Presentation Text Command Set
Table 55 (Page 2 of 2). End Suppression
Byte Value Description Error Code
3
X'F4'
X'F5'
End Suppression
Unchained
Chained
4 X'01' -X'FF' Suppression ID X'0202..01'
X'0204..01'
X'0298..01'
No Operation (NOP)
This control specifies a string of bytes that the printer ignores. The printer
ignores all parameter data. The data field can be a maximum of 253 bytes.
Table 56. No Operation
Byte Value Description Error Code
0-1 X'2BD3' Text Control Escape Sequence
2 X'02' -X'FF' Length X'021E..01'
3
X'F8'
X'F9'
No Operation
Unchained
Chained
4-255 Data (Ignored)
Overstrike (OVS)
This control identifies text that the printer overstrikes with a specified character.
The overstrike character prints using the font and character set that is active
when the printer receives the Overstrike command.
Note: If bit 7 is on, the printer treats all other bits in byte 4 as zeros, regardless
of their values.
An OVS command with a bypass value of 00 ends overstrike mode.
Table 57 (Page 1 of 2). Overstrike
Byte Value Description Error Code
0-1 X'2BD3' Text Control Escape Sequence
2 X'05' Length X'021E..01'
3
X'72'
X'73'
Overstrike
Unchained
Chained
68 6400 IPDS
To Next Page
Loading...
Need help?
General