Figure 11. Partially removing the front drives and llers
a) Push the drive tab (A) to release the drive lever (B).
b) Using the drive lever, pull the drive and ller about 2.5 cm (1 in) from the system.
c) Repeat steps “5.a” on page 14 - “5.b” on page 14 for the other drives and llers.
6. Label the front SAS cables. Press the cable connector latch and disconnect the front SAS cables from
the disk drive backplane as shown in the following gure.
14
Power Systems: Power Systems: Drive backplanes
To Next Page
Loading...
