IBM G8052 - Removing the Rackswitch Chassis from a System X or Power Rack

3. Slide the switch out of the rack.
4. Loosen and remove the M4 screws attaching the mounting bracket on each side
of the switch.
5
6
Removing the RackSwitch chassis from a System x or Power rack
To remove the RackSwitch from a System x or Power rack, complete the following
steps:
1. Disconnect all the cables.
2. Loosen and remove the M6 screws that secure the rear brackets to the front
brackets.
9
10 11
3
3. Slide the rear mounting brackets out of the slots available on the front mounting
brackets.
36 IBM System Networking RackSwitch G8052: Installation Guide