RPL-ROM-ERR: 103 There are multiple Ethernet adapters in the system. Specify the
correct serial number in NET.CFG.
RPL-ROM-ERR: 104 The Ethernet adapter EEPROM is faulty or not present.
RPL-ROM-ERR: 106 The Ethernet adapter is configured for Plug and Play in a non-Plug
and Play system.
RPL-ROM-ERR: 110 The Ethernet adapter RAM failed the memory test.
DHCP-related error messages
Error messages related to DHCP and the Ethernet adapter are shown in the
following table.
E61: Service boot canceled.
E62: Cannot initialize controller.
E63: Cannot initialize controller.
E67: Cannot initialize controller.
E6d: Cannot find BOOTP server.
E6e: Cannot start from downloaded image.
E71: Too many MTFTP packages.
M10: ARP canceled by keystroke.
M11: ARP timeout.
M20: Cannot copy memory.
M21: Cannot write to memory.
M22: Cannot write to memory.
M30: Cannot ARP TFTP address.
M31: TFTP canceled by keystroke.
M32: TFTP open timeout.
M33: Unknown TFTP opcode.
M34: TFTP read canceled by keystroke.
M35: TFTP timeout.
M38: Cannot open TFTP connection.
M39: Cannot read from TFTP connection.
M40: BOOTP canceled by keystroke.
M40: DHCP canceled by keystroke.
M41: BOOTP timeout.
M41: DHCP timeout.
M42: No client or server IP.
M43: No bootfile name.
Chapter 6. Troubleshooting 79
To Next Page
Loading...
Need help?
General