120 IBM Desktop System HMM
ATTENTION: Make sure to turn off the power before
manual disc eject operation.
CD-ROM Front Panel Introduction
Item Description
1 Load / eject button
2 Headphone jack
3 Power-on / busy indicator, lights up in
green color while disc is set in ready
state; lights up and flashes in amber color
during data read or seek operation.
4 Headphone volume control
5 Emergency eject hole.
See CD-ROM Emergency-exit <option 1>
below.
Disc tray and emergency eject
See CD-ROM Emergency-exit <option 2>
below.
CD-ROM Emergency-exit <option 1>
If for any reason the tray does not
eject automatically, insert and press
an eject-bar inside the emergency
eject hole to manually eject the tray. A
straightened paper clip with a diameter
of 1.2 mm (typical) can be used as an
eject-bar.
CD-ROM Emergency-exit <option 2>
Locate the bottom edge of the
disc tray. Gently pry the disk tray
open with a screwdriver. When
the disc tray opens, simply
remove the disc from the CD-
ROM drive.
To Next Page
Loading...
Need help?
General
