IBM NetVista Hardware Maintenance Guide

Check Procedures 37
- Check all adapter card jumper settings.
- Check all adapter card switch settings.
- Check all adapter card cables and connectors.
Make sure that all of the above are set correctly
and show the correct voltages and continuity. Re-
place any defective cables or adapter cards. See
“Parts/Test Point Locations” on page 107.
- Run the Diagnostics \ All Tests again.
- If an error or other symptom is displayed, go to
“Index of Symptoms, Messages, Error Codes, or
Beeps” on page 38.
- If no error can be detected or the symptom is in-
termittent, go to “Undetermined Problems” on
page 74.
•
End
009 -
•
If the last test stops and you cannot continue, first
make sure all switches, power connectors, cables,
and jumpers are set correctly and show the correct
voltages and continuity.
•
Take note of any messages, error codes, beeps, or
new symptoms. Go to “Index of Symptoms,
Messages, Error Codes, or Beeps” on page 38.
•
If there is no error symptom or the error symptom
is intermittent, go to “Undetermined Problems” on
page 74.

IBM NetVista Specifications

General

Category	Desktop
Model	NetVista
Processor Type	Intel Celeron
Memory Type	SDRAM
Optical Drive	CD-ROM, DVD-ROM, or CD-RW
Graphics	Integrated Intel graphics
Audio	Integrated audio
Network	10/100 Ethernet
Operating System	Windows 2000, Windows XP (Varies by model)
Expansion Slots	PCI
Ports	USB, serial, parallel, VGA, audio in/out