Test 8010
1 Check your wall outlet for proper operation (use
a working lamp).
2 Verify
that
the
Printer Cable is properly
connected to the printer and system unit.
Did you find any problem while doing the above
step?
NO -
Go
to the next step.
YES - Correct the problem and perform the
system diagnostic tests again.
3
Set the Power switches
on
the printer
and
system unit to Off.
(If
an
expansion unit is
attached, also set its Power switch to Off.)
4
Disconnect the Printer Cable.
April 1984
Test
8010-1
To Next Page
Loading...
