These three responses tell you that the POST has
successfully completed. Other information
will
appear
on
the screen and it
is
not important at
this time.
If
you have a diskette drive
and/or
a
printer (that you turned on), you will also hear
and see responses from these; ignore these
responses at this time.
Remember an error message will appear on your
screen if the system unit
is
turned
on
before the
expansion unit, if you have an expansion unit
installed. To recover, turn off the power to
all
devices then set the Power switch
on
the
expansion unit to On, then turn on the system
unit's power.
If
the responses were not correct,
or
if your
screen
is
not similar to the figure below, refer to
"Problem Determination Procedures."
The
IBM
Personal
Computer
Basic
Version
CX.XX
Copyright
IBM
Corp
XXXX
XXXXX
Bytes
free
OK
1
LIST
2RUN
3LOAD"
4SAVE
5CONT
6LPTI
'7TRON
8TROFF
9KEV
OSCREEN
Getting Ready 3-7