Note:
If
you do not have
an
IBM Cluster
Adapter, continue with "Power-On Self Test
(POST)"
on
the following page.
10
If
you have
an
IBM Cluster Adapter, it came
with a terminating plug. Disconnect
the
coaxial
cable from the Cluster Adapter's connector.
11
Refer to the figure below and install
the
terminating plug (IBM part number 6323481)
on
the Cluster Adapter's connector.
Continue with
"Power-On
Self Test
(POST)"
on
the following page.
Cluster
Adapter
Connector
Terminating
Plug
20-4
Start
April 1984
To Next Page
Loading...
