IBM S/390 - Logon Procedure (System Programmer Mode)

Default user identifications and passwords are established as part of a base Hardware Management
Console. The Access Administrator should assign new user identifications and passwords for each user
using the User Profiles task under Console Actions as soon as the Hardware Management Console is
installed. The default user identifications and passwords are:
Operator OPERATOR PASSWORD
Access Administrator ACSADMIN PASSWORD
Advanced Operator ADVANCED PASSWORD
System Programmer SYSPROG PASSWORD
For a list of what tasks are available depending on which user mode you are logged on to, see the
Hardware Management Console Operations Guide .
To log on, type the user identification and password combination assigned to you or one of the default
user identification and password combinations. Then press Enter, or select the Log on push button.
Once you log on, the Hardware Management Console workplace panel displays.
The tasks covered in this book require you to logon as either a Access Administrator or a System
Programmer. You will be instructed how to logon prior to each task. First, start by logging on as a
System Programmer using the default user identification and password if it has not already been changed
by your Access Administrator.
Logon Procedure (System Programmer Mode)
1. Type sysprog in the User identification field.
2. Type password in the Password field.
3. Select the Log on pushbutton with the mouse or press the Enter key.
If your log on is denied, see your Access Administrator for the new user identification and password
combination.
2-4 Getting Started