Step 1.2A: Input File On Diskette
If the I/O Configuration Program returns error messages in the IOCP source file, refer to the
IOCP Users
Guide
, GC38-0401.
Starting the Program:
1. Open Task List from the Views area.
2. Open CPC Configuration from the Task List Work Area
3. Open Groups from the Views area.
4. Select CPC from the Groups Work Area
5. Drag and drop the selected object on Input/Output (I/O) Configuration in the CPC Configuration
area.
The Input/Output Configuration panel displays.
Note: If the data set you want to change is write protected, select the data set, then select Options from
the action bar, then select Disable write protection from the pull-down.
Importing the Source File:
1. Under the title “Data Set Status,” select any valid data set (not the active one) that you want to
change.
2. Select Options from the action bar.
3. Select Import source file from the pull-down.
The extended option pull-down displays
4. Select Hardware Management Console diskette.
5. Select OK.
The Insert Diskette panel displays.
6. Insert the diskette which contains the source file into the Hardware Management Console diskette
drive.
7. Select OK
The Import From Diskette panel displays.
8. Select the name of the file on diskette.
9. Select OK
The Remove Diskette panel displays.
10. Remove the diskette from the diskette drive.
11. Select OK
Building the Data Set:
1. Select Options from the action bar.
2. Select Build data set from the pull-down.
The Build Configuration Data Set panel displays.
3. Select Ignore unrecognized card statements if there are MVSCP statements in addition to IOCP
statements.
4. If you want to build the data set for LPAR mode, select Build the IOCDS for Logically partitioned
mode
5. Select OK
The Confirm the Action panel displays.
(This panel only displays the first time a build is requested.)
6. Select Ok
3-6 Getting Started
To Next Page
Loading...
