1-10 Overview
•
ServeRAID M5015 controller - Support for 512-Mbyte 72-bit DDR2
800 MHz on-board SDRAM intelligent battery backed module
•
Two internal connectors
•
Support for RAID levels 0, 1, 5, 6, 10, 50, and 60
•
Advanced array configuration and management utilities
•
Online RAID level migration
•
Drive migration
•
Drive roaming
•
Media scan
•
No reboot necessary after expansion
•
More than 200 Qtags per array
•
User-specified rebuild rate
•
32-Kbyte nonvolatile random access memory (NVRAM) for storing
RAID system configuration information; the MegaRAID SAS firmware
is stored in flash ROM for easy upgrade.
1.6.1 SAS Features
The following list describes the SAS features of the ServeRAID M5014
and ServeRAID M5015 controllers:
•
Provides eight fully independent PHYs
•
Supports 6.0 Gb/s SAS data transfers per PHY
•
Supports SSP to enable communication with other SAS devices
•
Supports SMP to communicate topology management information
•
Provides a serial, point-to-point, enterprise-level storage interface
•
Simplifies cabling between devices
•
Provides a scalable interface that supports up to 240 devices through
the use of expanders
•
Supports wide ports consisting of 2, 3, or 4 PHYs within a single
quad port
•
Supports narrow ports consisting of a single PHY
•
Transfers data using SCSI information units
To Next Page