Table 18. Enclosure weight as FRUs are installed (continued)
Enclosure assembly Approximate weight
FRUs installed FRUs not installed kg lb
v Enclosure (01LJ607 or
01LJ112)
v Secondary expansion
modules
v Fascia
v PSUs
v Expansion canisters
v Fan modules
v Fan interface board
v 92 3.5-inch Near-Line
SAS hard disk drives
v Cover
138.6 305.6
Conversely, the overall weight of the expansion enclosure is reduced as you
remove parts. However, even with parts removed, the 2077-92F expansion
enclosure is heavy. Depending on the number of parts that remain, you might need
four persons or a mechanical lift to support the weight of the expansion enclosure.
Identify the hardware components: 2077-92F
You should become familiar with the external components of the 2077-92F
expansion enclosure.
Components on the front of the enclosure
Figure 22 shows the front of the 2077-92F expansion enclosure. In the figure, all
parts are installed in the enclosure.
▌1▐ Display panel indicators
▌2▐ Rack retention thumb screws
▌3▐ Power supply unit indicators
Figure 22. Features on the front of the 2077-92F expansion enclosure
Chapter 2. Installing the system hardware 41
To Next Page
Loading...
Need help?
General
