v 1 10 Gbps Ethernet port 3 which is the left port.
v 2 10 Gbps Ethernet port 4 which is the right port.
Table 45. Ethernet connections available with the control enclosure
Item Port Purpose
IP address is
assigned by
InitTool Use
3 (left port,
Figure 50 on
page 90)
Built-in Ethernet
port 1
1 Gbps external
network
connection
Yes Management
and service port
for each canister,
optional iSCSI.
(The Storwize
V7000 control
enclosure must
be able to
communicate
over the network
with the file
modules.)
3 (right port
Figure 50 on
page 90)
Built-in Ethernet
port 2
1 Gbps external
network
connection
No Optional
management
and service port,
optional iSCSI
1 (Figure 52) Ethernet port 3
on a 2076-312 or
2076-324
10 GbE external
network
connection
No Optional iSCSI
2 (Figure 52) Ethernet port 4
on a 2076-312 or
2076-324
10 GbE external
network
connection
No Optional iSCSI
If optional 4-port 10 Gbps Ethernet interface cards are installed in the node
canisters, connect each port to the network that will provide connectivity to that
port. Connect both node canisters in a control enclosure to the same networks to
provide redundant connectivity.
Figure 53 on page 92 shows the additional Ethernet ports when an optional 10
Gbps Ethernet interface card is present in PCI slot 3.
svc00733
1
2
1 2
Figure 52. 10 Gbps Ethernet ports on the rear of the Storwize V7000 enclosure
Chapter 5. Performing the hardware installation 91
To Next Page
Loading...
