Cabling the DS3300 power supplies
To connect the DS3300 power-supply cords, complete the following steps:
1. Connect a power cord to a power supply in the DS3300.
2. Attach the power cord to the strain relief guide that is on the underside of the
power-supply handle.
3. Repeat steps 1 and 2 for the second power supply.
4. Connect the other end of each power cord to a correctly grounded electrical
receptacle. For maximum protection against power loss, connect each of the
two power supplies to a different power source.
Chapter 3. Cabling the storage subsystem 41
To Next Page
Loading...
Need help?
General