v Ensure that the entered values for the ports values are available and not
used by other applications on your system. Use the command ″netstat -a″ to
verify the ports in use on your system.
v Specify two passwords for the SSL keys files. These passwords must
observe the following criteria:
– The passwords must contain at least 6 characters.
– Use the following options within the responsefile.txt file to set these
options:
- For the keystore use:
-W wasSslConfiguration.keystorePassword="your_keystore_password"
- For the truststore use:
-W wasSslConfiguration.truststorePassword="<your_truststore_password>"
Note: These options do not have default values. If you do not set
these values, the installation process fails.
5. Save the modifications to the response file.
6. Type the following command at the command prompt and press the Enter key
on your keyboard to start the installation process in silent mode: setup.exe
-options <responsefile-path>\<responsefile> -silent where
v responsefile-path — represents the path where the response file resides.
v responsefile — represents the relative name of the response file that you
used or created (for example, responsefile.rsp or responsefile.txt).
7. Wait for the installation program to install the product. This can take 5 - 10
minutes.
Note: During this processing, the installation process checks to see if the DS
Storage Manager server and DS Network Interface Server are already
installed and if they are the current version or have to be upgraded. If
they are already installed and need to be upgraded, the installation
process performs this function using the already set values from the
previous server installation, found on the system in the server
configuration files, for all the associated values. The specified values in
the response file are ignored.
8. Check the install log file for any possible error messages. This file is located in
the xxx\logs\install.log directory, where xxx is the destination directory where
the IBM TotalStorage DS Storage Manager is installed.
9. Start the IBM TotalStorage DS Storage Manager, if no errors are evident.
10. Perform the postinstallation tasks when the DS Storage Manager has been
installed successfully. You can access the instructions for the postinstallation
tasks from the postinstallation.txt file, in the doc directory on the product CD.
The following is an example of the template response file that is created when you
process the previous steps.
38 DS8000 User’s Guide
|
|
|
|
|
|
|
|
|
|
To Next Page
Loading...
Need help?
General