Note: The DS Storage Manager is not supported on any Windows 64-bit operating
system.
The unattended (silent mode) upgrade option allows you to run the upgrade
program unattended. Use this method of upgrade to issue a command from a
command prompt window, in the root directory of the IBM TotalStorage DS Storage
Manager CD.
Perform the following steps to upgrade the IBM TotalStorage DS Storage Manager
in your Windows environment using the unattended mode:
1. Log on to your Windows system as an administrator.
2. Insert the IBM TotalStorage DS Storage Manager upgrade CD into the CD-ROM
drive. If the interactive mode starts, click the Exit selection on the LaunchPad
window to exit.
3. Type the following command at the command prompt and press the Enter key
to start the upgrade process in silent mode: setup.exe -silent
4. Check the install log file for any possible error messages. This file is located in
the xxx\logs\install.log directory, where xxx is the destination directory where
the IBM TotalStorage DS Storage Manager is installed.
5. Start the IBM TotalStorage DS Storage Manager, if no errors are evident.
6. Perform the postinstallation tasks when the DS Storage Manager has been
installed successfully. You can access the instructions for the postinstallation
tasks from the postinstallation.txt file, in the doc directory on the product CD.
52 DS8000 User’s Guide
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
To Next Page
Loading...
Need help?
General