IBO MAGI 2 - Conditions of Use

25
Conditions of use
• Permissible ambient temperature from 0°C to + 40°C.
• Maximum permissible relative humidity (RH) 95%
• Permissible heating medium temperature +2°C~95°C. To prevent condensation of
steam on the control panel and the stator, the temperature of the heating medi-
um circulating running through the pump must always be higher than the ambient
temperature.
• The permissible maximum pressure in the system is 1.0 MPa (10 bar)
• Protection rating IP 44
• Pump input signal
• To avoid damaging pump bearings by cavitation, the following minimum pressure
must be maintained at the pump input:
Heating medium temperature [°C] <85°C 90°C
110°C
Minimum input pressure
0,05 bar 0,28 bar 1,0 bar
0,5 m of H
2
O
column
2,8 m of H
2
O
column
10 m of H
2
O
column
Heating medium
Thin, clear and non-explosive liquid not causing corrosion does not contain any solid parti-
cles, bres or mineral oil. The pump cannot be used to transport inammable or explosive
liquids such as vegetable oil or petrol. If the circulation pump is used to pump highly viscous
liquid, the pump eectiveness will drop. In such a case, a stronger pump must be used to
obtain proper parameters.