If the cycle is manually interrupted after it reaches the
drying phase, the items inside the sterilizer may be
considered sterile.
Note: Considering that the cycle has been interrupted
during the drying phase the materials and instruments
inside the chamber may be wet.
If the cycle is manually interrupted before it reaches
the drying phase, the items inside the sterilizer must
be considered not sterile.
Caution: Depending on the phase of the
cycle, steam and water can escape from
the sterilization chamber when you open
the door.
Delay start cycle
Tap “Delay Start” to schedule or modify a delay start cycle. The screen will show the current
configuration.
Tap “ ”to enter in the configuration menu.
Select the program then tap “Tap to set a delay cycle”.
Select the program then tap on the time and date and adjust it using the numeric keypad.
Tap “Disable” to set the delay start cycle once or daily. Tap “↵”to save and back.
To Next Page
