iCharger 308DUO - Calibration Procedures

308DUO V1.1.0
Synchronous Balance Charger/Discharger
- 30 -
 Calibration
Select SYSTEM MENU→Charger Setup→Calibration to enter the setup interface. User Calibration may result in large
data deviation, affecting normal use; so User Calibration is not suggested.
If the user select User Calibration, the User Calibration option changes to active status; then select channel to enter the
interface to calibrate.
Note: User Calibration has CH-X Channel Calibration and Other Variables Calibration two options, the
user can calibrate charger for one channel alternatively. If the user selects User Calibration, the
corresponding message will appear in the interface after booting the charger, as shown in the
right picture above.
Select CH-1/2 Channel Calibration to enter the channel calibration interface, Select Other Variables Calibration to enter
the other variable calibration; after Calibration, click " " to save and return to the previous interface; click " "
to load default value.
Channel Calibration Other Variables Calibration