iCharger 308DUO - Special Operational Notes

308DUO V1.1.0
Synchronous Balance Charger/Discharger
- 38 -
Important Notes
 The Charging Principle for Reflex Charge Mode
 Power Regenerative Mode
 Channel Regenerative Mode
Channel Regenerative Mode
Note: Reflex charge mode only supports NiMH and
Pb battery. Does not support lithium battery.
Using reflex charge mode to charge battery can
reduce effectively the heating of the battery. Go to the
MEMORY SETUP → Charge → Chg Mode to select
Reflex mode.
Note: Power Regenerative Mode: which is when the
power supply for the charger acts as "battery power",
the charger will regenerative charge for "battery
power" during the process to discharge the battery.
Go to MEMORYSETUP → Discharge → Regenerative
-Mode to select To input mode.
Note: Channel Regenerative Mode is for discharging
from one channel to another channel, the current
version only supports resistor and bulbs discharge, but
later versions will support the battery regenerative.
Go to MEMORY SETUP→ Discharge →
Regenerative Mode to select To channel mode.
1: Regenerative power
2: Regenerative voltage limit
3: Regenerative current limit
1
2
3