308DUO V1.1.0
Synchronous Balance Charger/Discharger
J2 can be used as an external power source: If J1(5V/1A) cannot provide the voltage needed for the servo, please
connect through J2 with external power source.
Select the test mode and go to the following corresponding interface.
Liner Test: When turning the knob,
the pointer deflects with the setting
value of Step, and the servo responds
accordingly.
Fixed Point Test: When turning the
knob, the pointer deflects among
each setting value and the servo
responds accordingly.
Auto CW/CCW Test: Click Test
button then the pointer deflects the
setting times at a set rate back and
forth among each setting values,
and the servo responds accordingly.
Speed Test: Click Test to read the test
curves and test results.
Note: Current Sample, is the sampling
value the AD for servo current, there
are 300 sampling point in total.
300 * sampling rate = the entire
sampling time, which must be larger
than the servo speed, if not, it will fail
to test the speed.
To Next Page
Loading...
