To Next Page

To Previous Page

The conﬁguration mode is used to set the SC2311 to match your heating/cooling system. The SC2311 functions with heat

pump, air conditioning, gas, oil or electric heat systems.

To conﬁgure the SC2311, perform the following steps:

1. Remove the cover of the thermostat by gently pulling on one of the corners.

2. S

imultaneously hold the SW5 and SW6 buttons in for 5 seconds while the SC2311 is in OFF mode.

3. Press the or button to change settings within each screen.

4. Press the

SW6

button to advance to the next screen.

Note: The

SW5

button will return you to the previous screen.

5. To exit conﬁguration mode, slide the Mode switch to Heat or Cool.

Conﬁguration Mode Settings

The twelve (12) setup screens for Conﬁguration Mode are as follows:

1. Heat Pump and Non Heat Pump – Press the or button to conﬁgure as heat

pump, or non-heat pump system. For heat pumps, there will be an anti-short

cycle delay for heating and cooling.

• 1 = Heat pump system

• 0 = Non-heat pump system

Press the

SW6

button to advance to the next screen.

FILTER

DIFF

ROOM

SET

REMOTE

FILTER

DIFF

ROOM

SET

REMOTE

2. Heat Source (Gas or Electric) – (Appears for non heat pump systems only)

Change between “g” (Gas) and “E” (Electric).

Press the or button to set heat source.

Press the

SW6

button to advance to the next screen.

Conguration Mode

ICM Controls SC 2311 User Manual

Questions and Answers: