What to do if the ICM Controls SC 2201 LCD is blank?
If the ICM Controls Thermostat's LCD is blank, and there's no display, the issue might be a lack of voltage. Check the circuit breaker or look for an open fuse to resolve this.
Why is the temperature display not accurate on my ICM Controls Thermostat?
If the temperature display on your ICM Controls Thermostat is not accurate, your thermostat offers both Fahrenheit (default) and Celsius readouts. Verify that the jumper is correctly set to your preferred unit. Additionally, seal the wiring hole behind the thermostat with non-flammable insulation to prevent airflow.
How to stop ICM Controls SC 2201 from continuously turning on and off?
If your ICM Controls Thermostat is continuously turning on and off, increase the temperature differential. See the section on Setting a New Temperature Differential for instructions.
How to troubleshoot an ICM Controls SC 2201 that is not turning on?
If the system is not turning on with your ICM Controls Thermostat, check the wiring. Please refer to the Installation section for guidance.
Why does my ICM Controls SC 2201 not turn on the system frequently enough?
If the ICM Controls Thermostat isn't turning on the system frequently enough, decrease the temperature differential. Refer to the section on Setting a New Temperature Differential for instructions.
What to do if my ICM Controls SC 2201 is not properly controlling the fan?
If the ICM Controls Thermostat is not properly controlling the fan, check the wiring. Refer to the Installation section for guidance.
Lists key advantages and operational features of the thermostat.
Details items included in the package and tools needed for installation.
Provides a brief overview of the thermostat's capabilities and intended use.
Step-by-step guide to safely remove the old thermostat.
Explains how to label wires from the old thermostat for correct new wiring.
Describes how to adjust the desired temperature setpoint for heating or cooling.
Explains how to adjust the temperature differential to control system cycling frequency.
Instructions to switch the display between Fahrenheit and Celsius units.
Details the steps to begin operating the thermostat after installation.
General| Stages | 2 Heat / 1 Cool |
|---|---|
| Power Source | 24 VAC |
| Programmability | Non-programmable |
| Display | Digital |
| Backup Battery | No |
| Weight | 0.3 lbs |
| Type | Non-Programmable |
| Compatibility | Heat Pumps |
To Next Page