ICM Controls SC 2201 - Installing the Thermostat

5
ELECTRICAL SHOCK HAZARD – Turn off power at the main service panel by removing the fuse
or switching the appropriate circuit breaker to the Off position before removing the existing
thermostat.
 IMPORTANT: Thermostatinstallationmustconformtolocalandnationalbuildingandelectricalcodesand
ordinances.
 IMPORTANT: Thisthermostatiscompatiblewith100%lockoutsystems.Toresetthesystem,turnthermostat
toOffpositionforatleast60seconds.
 Note: Mountthethermostataboutvefeetabovetheoor.Donotmountthethermostatonanoutsidewall,
indirectsunlight,behindadoor,orinanareaaffectedbyaventorduct.
1. Turnoffpowertotheheatingandcoolingsystembyremovingthefuseorswitchingofftheappropriatecircuit
breaker.
2. PutMode switchinOffposition.
3. PutFan switchinAutoposition.
4. Toremovecover,insertandtwistacoinorscrewdriver
intheslotsonthesidesofthethermostat.
5. Putthermostatbaseagainstthewallwhereyouplantomountit(Besurewireswillfeedthroughthewireopening
inthebaseofthethermostat).
6. Marktheplacementofthemountingholes.
7. Setthermostatbaseandcoverawayfromworkingarea.
8. Usinga3/16”drillbit,drillholesintheplacesyouhavemarkedformounting.
9. Useahammertotapsuppliedanchorsinmountingholes.
10. Alignthermostatbasewithmountingholesandfeedthecontrolwiresthroughwireopening.
11. Usesuppliedscrewstomountthermostatbasetowall.
Cool Off Heat Emer Auto On
Mode Fan
To Install Thermostat